I believe there is a 4th type of No Read: Ball is hit, top light goes red, everything seems normal but no signal is acknowledged. While this may be a transmission issue, I believe it is more of a read issue. I've found that this happens most often when I hit a shot immediately after the lights go green. If I delay a few seconds, this rarely happens. Also, I think lighting is an issue -- too much light, especially around 5600k (daylight) seems to be worse than too little light. No conclusions here, just theories and anecdotal experience. Love my Skytrak; definitely not a POC.
- Golf Simulator Forum is the center point for discussion on golf simulator products, brands, manufacturers, launch monitors and everything else related to golf simulation.
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.
Comment