TGC/Protee - GSX Settings and Bluetooth adapter

Collapse
This is a sticky topic.
X
X
 
  • Time
  • Show
Clear All
new posts
  • SFR
    Super Member
    • Aug 2014
    • 621

    #16
    Do you have the Foresight range software? If so could you pitch the ball and stop it like you are trying now?

    Also make sure you also have the Course friction at 1.65 and greens as 1.00 as these are the setting I tested my settings with. There is not a lot of backspin set at max and make sure if you do set the wedges at max that you select a wedge in the Protee game before you hit.

    Same goes for Driver and woods, where they are set differently as if I hit my driver with the driver setting it is ok, but if I hit my fairway woods with the Driver selected it is off a bit.
    Mountain Time

    Comment

    • HWoods
      Super Member
      • Aug 2014
      • 695

      #17
      Very interesting, SFR. My friction/greens setting must still be default. I have been changing between fairway woods and irons when I play iron shots in. I have not changed anything when I chip/pitch. I'm assuming a wedge is selected by default (I'll check) so it wouldn't make a difference.

      Comment

      • Maverick
        Offline
        • Aug 2014
        • 289

        #18
        Well, there it is. Like SFR said, if you want to use the GSX adjustments, you have make sure you select the correct type of club in the game for the adjustments to work correctly. But a wedge is selected by default when around the green.

        Also, it's very important to set Course Friction to 1.65 and Green Friction to 1.00.

        Comment

        • HWoods
          Super Member
          • Aug 2014
          • 695

          #19
          Ya, that's what I've been doing. I haven't changed any course friction or green though, that's for sure. I'm playing in 30 mins or so and I'll check and restart the GSX before I start a game.

          Comment

          • HWoods
            Super Member
            • Aug 2014
            • 695

            #20
            Ok so much better today. The chip and run was good. The putting was also much better, but I played a different course and this could have something to do with it.

            I'm seeing low carries on low spin drives. I'll investigate that further tomorrow. Thanks guys.

            Comment

            • Maverick
              Offline
              • Aug 2014
              • 289

              #21
              Did you change the course friction to 1.65 and green to 1.00?

              Comment

              • HWoods
                Super Member
                • Aug 2014
                • 695

                #22
                Yep.

                Comment

                • Bubba22
                  Sim Guru
                  • Aug 2014
                  • 2992

                  #23
                  Excellent Rick. You will enjoy. Keep tweaking. Like I said there are very few companies that will listen to your needs and adjust, certainly not Foresight. The goal is to get it reacting as your games plays. Nothing is perfect and really it doesn't have to be perfect, just realistic.

                  Comment

                  • Pades
                    Junior Member
                    • Aug 2014
                    • 3

                    #24
                    I just got my Protee software up and running last night and am loving it. Thanks to SFR for help with the initial GSX settings as well. One minor issue though. Does anyone know if it is possible to adjust the view so that the aiming pole is not dead center on the screen (ie as in adjusting the DX/DY etc in the Foresight software)? As it is, I am set up slightly to the right side of the screen due to space constraints, so I can't rely on my eyes looking at the screen when I set up to hit a shot with Protee, as the aiming pole is to the left. Obviously I still know where my shot will go if I hit it square, but it would be nice to have it both ways. Thoughts? Or should I start knocking down walls...

                    Comment

                    • jeremiah
                      Advanced Member
                      • Aug 2014
                      • 271

                      #25
                      I dont believe you can adjust that in the game. But you could just use the horizontal adjustment option on your projector to shift the entire picture over until it lines up, thats how i got mine lined up perfectly. If its quite a ways off, you could move your projector too.

                      Comment

                      • Pades
                        Junior Member
                        • Aug 2014
                        • 3

                        #26
                        Thanks I'll give that a shot, and I can probably move myself a little over to the center , and hopefully get it close enough. Just hoping to avoid hurting the windows or my driver (more importantly)

                        Comment

                        • SFR
                          Super Member
                          • Aug 2014
                          • 621

                          #27
                          I went back into test Irons and wedges with both Foresight and Protee software running at the same time to display the same shot from the same spot in the Brabazon course. I had boosted the wedges to what I thought looked good but dropped back to the 45 range and after a couple more rounds some of the lob shots were stopping too quick.

                          Here is the adjusted areas. Carry ADJ for Irons (21) one higher and Wedges (19) one lower
                          Spin Adj Irons (31) Wedges (36)

                          When these settings were used side by side with the two softwares, the irons were within 1 yard of carry and end roll on the greens. Most shots resulted in the yardage left to the pin to be about 1 yard appart. The fairways in Foresight are a bit faster and the ball runs a bit more there but when looking at carry dist. these settings should be a bit better now.
                          Mountain Time

                          Comment

                          • Maverick
                            Offline
                            • Aug 2014
                            • 289

                            #28
                            Awesome stuff! Thanks SFR.

                            Comment

                            • HWoods
                              Super Member
                              • Aug 2014
                              • 695

                              #29
                              Thank you SLR!

                              Comment

                              • SFR (GC2 User)
                                Super Member
                                • Aug 2014
                                • 621

                                #30
                                There is a new update for the GSX. This version 0.4.9 has a new slider for the green side bunker distance. Beyond that setting the bunkers will be using your fairway bunker settings. They were set to 27 yds so any longer bunker shots were using less penalty.

                                Also I read Rick's post about low spin Drives that seem to not carry right. I think this is a GC2 issue as I have struggled with the Driver and fairway woods on the GC2. If in fact it has something to do with the low back spin and their calculations this may help.

                                If you boost the backspin on the Driver and woods it does seem to help straighten out the Driver. I normally hit my Driver with an average 240 to 250 carry and not always a massive slice or hook. My 17 deg Rocketbalz 5 wood like, is very straight and carry 220 to 230 on average with little issues. On the GC2 it's often a slice or hook. By boosting the backspin in the GSX interface it does help with this.

                                I had another golfer over the other day and he too
                                Mountain Time

                                Comment

                                Working...