Protee : How to setup machine vision cameras

[Maverick]

V-cam is looking much better and much more like mine.

You can offset you putting sensor but not too much. The cable is only so long. You will have to get wider beam light over the putting sensor and also point it slightly back towards the center line. CAn't do to much as that will start to affect the putts. Which why you should not off set the putting sensor too much. Play with the placement until it all works then make it permanent.

[Jonnystick]

Thanks Zmax...sounds like to get my best results I need to just have the putting sensor line up with my mat. If it is 18" offset I guess I will just have to get used to it. Thanks again for the help with the launch camera.

[Maverick]

No problem. Join the tour and have fun playing online once you get it all tweaked.

[Bubba22]

Looks better. Don't offset the putting sensor too much. Once done, join us online.

[Jonnystick]

Zmax or Bubba - my launch is good now but my ball path is constantly left by 2-3 degrees and my club face is closed 2-3 degrees. I am a very consistent ball striker and although I generally hit a very slight draw this just does not seem right. It is very difficult to make the ball path go to the right. Do you know why this is happening and how I can fix it? Thanks

[Bubba22]

In interface, under settings - use ball track for ball path calculations - is that set as yes?

You don have a Hcam right? Make sure the Hcam settings in interface are turned off.

[Jonnystick]

Bubba both of those were set correctly. Any other ideas?

[Maverick]

According to the ball flight laws, that is exactly what is suppose to happen. Does this happen even when the ball clearly went right of the target line? If so, it probably just a setting or maybe your sensor mat light is not pointing straight down. Is the sensor mat light directly above the sensor mat?

[Throttle]

Also check these settings out and let us know what they are set too.

Club_path_correction_Driver=
Club_path_correction_Wood=
Club_path_correction_Iron=-

Club_face_correction_Driver=
Club_face_correction_Wood=
Club_face_correction_Iron=

[Jonnystick]

Club_path_correction_Driver=-1 Club_path_correction_Wood=-2 Club_path_correction_Iron=-3 Club_face_correction_Driver=2 Club_face_correction_Wood=3 Club_face_correction_Iron=3 These are my setting....Should I adjust?

[Jonnystick]

Also do you click on for use v-cam for spin. Thanks

[Maverick]

No, its still beat. And answer my questions above.

[Jonnystick]

Zmax- yes the light Is directly above the mat. I can get it to go right of the target line but it is very difficult. If I hit a solid 7 iron it will end up about 15-20 yards left of target.

[Maverick]

Post a screenshot of shot analysis screen along with the interfaces main screen. Side by side if you can.

[Jonnystick]

Zmax- I am hoping to post images in another day or two. I Live in Buffalo and dealing with a snowstorm. Had one more question about H cam. Is it worth it? With shipping it is $375. I thought this was included in my package but was wrong? Is there any other cheaper camera options out there?